Where is Texture's ignition switch?

Official support for: ugoaudio.com
frank246
KVRer
6 posts since 25 Apr, 2012 from Bloomington, Indiana, USA

Post Fri Dec 06, 2013 10:52 pm

I am a visual artist experimenting with various VSTs. I used Texture (within VST Host) some months ago with very pleasing results... but now cannot figure out how to get the guldern-blinkity thing to make any sound. Could anyone help this old man get Texture chugging along again? It would be much appreciated.

Inasmuch as I have no musical experience at all and many VSTs have me baffled, simple worded instructions may be required.

ugo
KVRAF
5016 posts since 6 Jan, 2003

Post Wed Dec 11, 2013 5:55 am

Replied via email, but if you encounter any further problems please do let me know. :)

frank246
KVRer
6 posts since 25 Apr, 2012 from Bloomington, Indiana, USA

Post Wed Dec 11, 2013 8:08 am

I just want to say thank you for your help and offer some info to any other complete newbies who might wander by here. Mid email exchange, I discovered some earlier written notes that indicated I had chained a sequencer in front of Texture. I tried that and, of course, Texture then worked perfectly. I should also clarify that I erroneously wrote above that I couldn't get any sound, when, in fact, I could get single note sounds using a built-in keyboard. Happy new year! :D

Return to “Ugo”