MPE forwarding through NerdSeq
Posted: Fri Jun 19, 2026 9:16 am
Hello! I have a pretty specific question that I was wondering if maybe anyone had any experience with.
I have a Linnstrument as the controller and a Disting NT, which has several MPE "instruments", but also a lot of other algorithms that can run concurrently. Therefore, it would be pretty limiting to ONLY have the Linnstrument connected to the only midi port, as the Linnstrument would be controlling a single voice out of maybe 5-6 and drums etc.
So I wanted to run the Linnstrument into the Nerdseq sequencer and then forward the incoming midi to the Disting NT. This works well enough (I assign all MPE channels to a single Nerdseq Midi track) and I am able to play the Disting with the Linnstrument, but pitchbend bends every note.
Does anybody know of a way I can set this up?
I have a Linnstrument as the controller and a Disting NT, which has several MPE "instruments", but also a lot of other algorithms that can run concurrently. Therefore, it would be pretty limiting to ONLY have the Linnstrument connected to the only midi port, as the Linnstrument would be controlling a single voice out of maybe 5-6 and drums etc.
So I wanted to run the Linnstrument into the Nerdseq sequencer and then forward the incoming midi to the Disting NT. This works well enough (I assign all MPE channels to a single Nerdseq Midi track) and I am able to play the Disting with the Linnstrument, but pitchbend bends every note.
Does anybody know of a way I can set this up?