[SOLVED] MStereoProcessor: activity shown w/o any audio
-
- KVRAF
- Topic Starter
- 3645 posts since 3 Nov, 2015
It is puzzling that MStereoProcessor shows activity with the phase scope and the width meter constantly moving when there's no audio at all. The project was opened and the transport was not started but still, these meters are showing constant rapid activity. What gives ? And what to make of that when reading these meters during playback ?
Cheers.
Cheers.
You do not have the required permissions to view the files attached to this post.
Last edited by mevla on Mon Aug 13, 2018 10:24 am, edited 1 time in total.
-
- KVRAF
- 10310 posts since 2 Sep, 2003 from Surrey, UK
All is silent here (in Reaper 5.92). And, yes, I selected the same preset.
What host are you using?
What host are you using?
-
- KVRAF
- Topic Starter
- 3645 posts since 3 Nov, 2015
I use the latest Bitwig which is a beta release. What would be the chances of introducing noise in a beta release ? I mean, that part of the software should be stable.
-
- KVRAF
- Topic Starter
- 3645 posts since 3 Nov, 2015
Further troubleshooting has shown that there's actually noise when nothing is playing at it comes from the Repro-5 synth programmed with a bass preset.
EDIT: It's actually not the Repro-5 synth itself, but one of the FX that's part of it, the Lyrebird echo/delay unit.
EDIT: It's actually not the Repro-5 synth itself, but one of the FX that's part of it, the Lyrebird echo/delay unit.