KVR Audio

odo · Post by **odo** » Fri Jul 04, 2014 9:15 pm

I'm using (dd_dblClkReset) when you hit the button the popup menu shows an other note
Don't know if it's the pop or the bitmap

RunBeerRun · Post by **RunBeerRun** » Fri Jul 04, 2014 9:27 pm

You could try hooking up a volt meter, located in modules/controls. You're using a lot of float stuff there, might need a convertor(subcontrols menu or KDL module maybe)

also make sure on the dd doubleclickreset you've set the reset value to where you want it

that's my guesses

odo · Post by **odo** » Fri Jul 04, 2014 9:49 pm

Thanks gonna try it

odo · Post by **odo** » Sat Jul 05, 2014 7:53 pm

Forgot to say most of the time it's ok and that this happens

odo · Post by **odo** » Sat Jul 05, 2014 8:00 pm

odo wrote:Forgot to say most of the time it's ok and this happens

RunBeerRun · Post by **RunBeerRun** » Sun Jul 06, 2014 9:19 pm

Hmmm ok, other than my guesses, I don't know-I only work with any subcontrol or really any float stuff at all, rarely, when needed.

odo · Post by **odo** » Sun Jul 20, 2014 7:05 pm

Working on a new gui
BTW i want a filter distortion Now i used a osc to the cutoff with a high frequency IT's fun but still not what i want

mztk · Post by **mztk** » Fri Sep 05, 2014 6:33 pm

tip for dd reset/random: only attach it to the patchmem,
or via image to frame>int to list if controlling a GUIList.
then you just have the bools line for reset+random.

if you DH popup is attached to the same thing, it could maybe
popup when you don't want it. can you isolate it via another path
with something that is one way eg: a KDL module?
if you want to block direction with GUIBools you can use AND or OR
with a single input, etc.

Random problems