A nit for the "Whish list"
-
- KVRist
- Topic Starter
- 81 posts since 11 Jun, 2009
This is only a small annoying issue not a "show stopper" but a bigger window for the delete connection prompt in the DEEP EDIT mode would be handy.
When there's more than one connection and they come from the same type of module (event monitor for example) then the window isn't big enough to see the module number so you don't know which event monitor you're selecting for the connection deletion.
With complex MUXs and my on going need to do a lot of monitoring to track down what's working and what isn't I end up having to do a lot of connedtion deleting and deleting all isn't the best option.
John
When there's more than one connection and they come from the same type of module (event monitor for example) then the window isn't big enough to see the module number so you don't know which event monitor you're selecting for the connection deletion.
With complex MUXs and my on going need to do a lot of monitoring to track down what's working and what isn't I end up having to do a lot of connedtion deleting and deleting all isn't the best option.
John
- KVRAF
- 12740 posts since 24 Jun, 2008 from Europe
-
- KVRist
- Topic Starter
- 81 posts since 11 Jun, 2009
Thanks!mutools wrote:You're right, will be tuned in the next version, thanks!
John
-
- KVRAF
- 2938 posts since 18 Jul, 2005
Any plans to make it possible to select wires themselves at any point (either by wire body or a midpoint)? The input/output pin selection is fast enough if you have only one connection to a particular pin, but having to use the menus is a bit of a drag with multiple connections compared to just looking at and clicking on the wire you want.
- KVRAF
- 12740 posts since 24 Jun, 2008 from Europe