Zebra Trance Pad (based on Sylenth1)

[5Lives]

Hello,

I posted this in the Zebra forum, but may get additional responses here. I'm trying to mimic the KEY BigSynth preset from the Sylenth1 demo. I've gotten pretty close - you can check out the sound sample below (Sylenth1 is first then Zebra) and my Zebra preset.

http://www.mediafire.com/file/naumwduzm ... arison.mp3

http://www.mediafire.com/file/2z3ez3itx ... %20Pad.h2p

Any thoughts of what I could do in Zebra to get even closer?

Thanks,
C

[mcnoone]

I'm blocked from mediafire. Could you upload it to this site.
http://www.megafileupload.com/index.php
I'd like to have a go at it.

[5Lives]

http://www.megafileupload.com/en/file/1 ... n-mp3.html

http://www.megafileupload.com/en/file/1 ... d-h2p.html

[mcnoone]

Thanks for that upload change.
Here's what I did with it after an hour.
If you listen to only osc1, you'll here a very bright saw. Then look at the osc spectral fx to see how I got that brightness, and you'll never have that problem again on any tone not being bright enouph.
The organ tone in osc3, was done by using the register spectral fx.
The hard strike hit needs it's own envelope.
The bell tone is osc4.
Haven't played around with the tuning enouph. I'll try later.
Hope it gets you closer. I like the Sylenth presets a lot.
http://www.megafileupload.com/en/file/1 ... d-h2p.html

[mcnoone]

Here's a updated version. I think much closer.
http://www.megafileupload.com/en/file/1 ... d-h2p.html