KVR Audio

Juljan · Post by **Juljan** » Thu Sep 11, 2014 8:38 pm

Hey guys,

I have some trouble with KRKs 6 and my PC:
While(!) using it, auto-standby turns on. Normally it is enough to turn volume on and then you have to wait for a few seconds until they return from standby. But, of course, it is annoying if this happens every 30 minutes. So, is it possible to turn auto-standby off or is there any other trick with the same effect?

Best regards
Juljan

Juljan · Post by **Juljan** » Tue Sep 16, 2014 7:45 pm

Nobody?

BertKoor · Post by **BertKoor** » Wed Sep 17, 2014 3:00 pm

If auto-standby kicks in while you feed them a signal, better get back to the shop and ask for service under warranty. It's only supposed to be happening when they're silent for 30 minutes.

Maybe you feed them a very low level, below it's threshold. Then simply raise your master fader on the audio interface and lower the volume knob on the monitors. That way you get a better signal/noise ratio anyway.

Trouble with KRK's auto-standby