Midi Clock Message
-
mikechristiansen2000 mikechristiansen2000 https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=318019
- KVRer
- Topic Starter
- 10 posts since 8 Dec, 2013 from United States
I want the use the midi clock message in an application. MuLab seems to be sending short message 240 for the midi clock. The midi standard calls for 248. Message 240 is System Exclusive. Why this difference or am I doing it wrong? Thanks
-
- KVRAF
- 12739 posts since 24 Jun, 2008 from Europe
MuLab sends out midi clock messages with status byte F8 hex = 248 dec. Don't know why you're seeing sysex start bytes.
-
mikechristiansen2000 mikechristiansen2000 https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=318019
- KVRer
- Topic Starter
- 10 posts since 8 Dec, 2013 from United States
OK. Ill look more carefully.
Just to be sure.. These messages are being sent to my PC application from the port selected from the "Choose Midi Clock Module" context menu on the BPM display. I am using the midi output port selected in the MIDI setup dialog from the MULAB menu.
-Mike
Just to be sure.. These messages are being sent to my PC application from the port selected from the "Choose Midi Clock Module" context menu on the BPM display. I am using the midi output port selected in the MIDI setup dialog from the MULAB menu.
-Mike
