MUTOOLS

wibem · Post by **wibem** » Thu Jul 30, 2015 4:58 am

When I mute all modules, there should be no sound. But there is a sound.
Seems to be a bug.

pljones · Post by **pljones** » Thu Jul 30, 2015 6:19 am

You have the Send on Jaam 4 Rack before the Mute cut, so the send is still active. You've moved the cut mark on the Tal-u-no-lx-V2 rack to the top, so the send gets cut. I imagine it's only Jaam 4 you hear?

wibem · Post by **wibem** » Thu Jul 30, 2015 8:18 am

It's the TAL-UNO module, which I hear without effects.
I even hear it, if all Sends are muted.

bibz1st · Post by **bibz1st** » Thu Jul 30, 2015 9:14 am

what does your project modular area look like ?

wibem · Post by **wibem** » Thu Jul 30, 2015 10:59 am

This is the module area.

bibz1st · Post by **bibz1st** » Thu Jul 30, 2015 12:03 pm

I set a project up the same, using 2 Basic Synths instead of the instruments you are using and I get the same behaviour. I believe if you give JAAM the Focus and move the Pre/Post Fader Selector to the top then you will most likely hear that one instead.So I guess the solution is move the Selector to a different, lower, slot.

pljones · Post by **pljones** » Thu Jul 30, 2015 5:52 pm

wibem wrote:It's the TAL-UNO module, which I hear without effects.
I even hear it, if all Sends are muted.

Hm, perhaps I mistake the order the mute and cut markers interact. Try moving the marks down after all the plugins in each rack you want muted.

bibz1st wrote:So I guess the solution is move the Selector to a different, lower, slot.

Mm, I should have tried it

.

MUTOOLS

KVR Audio

Muted modules play