strange problem with syncpressor
-
- KVRer
- Topic Starter
- 14 posts since 25 Dec, 2021
so when using syncpressor, im having a pretty weird issue in that all the knobs are stuck basically at their default position. i’m able to adjust them only in the almost smallest possible amount and then it’s stuck. for example, i can adjust the threshold down .1, sometimes up to .3, from its default setting, and that’s it. it’s the same issue with all the knobs. all i can do to actually dial anything in is to manually type in the amounts, which is a huge PITA when you’re trying to set up a compressor. for all practical purposes, it’s unusable for me.
to my knowledge there’s only one version of the plugin, 1.0.1, and i’m on a 2020 m1 mac running logic
to my knowledge there’s only one version of the plugin, 1.0.1, and i’m on a 2020 m1 mac running logic
-
- KVRist
- 52 posts since 12 Jan, 2022
your support at HoRNet plugins. Need help? Just open a ticket
-
- KVRer
- Topic Starter
- 14 posts since 25 Dec, 2021
apparently i’m just having bad luck all around because when i try to start a new support ticket im redirected to my downloads. then i click support and click to start a new ticket, rinse, repeat
but to answer your question, native
but to answer your question, native
-
- KVRist
- 52 posts since 12 Jan, 2022
Hi,
thanks for your clarification, we will look into this issue and -if needed- we will provide a fix in the next plugin upgrade.
Cheers
Maso
thanks for your clarification, we will look into this issue and -if needed- we will provide a fix in the next plugin upgrade.
Cheers
Maso
your support at HoRNet plugins. Need help? Just open a ticket