Spire 1.5.8 - Shaper Tube 1 mode Denormalization issue
- KVRian
- Topic Starter
- 1104 posts since 31 Aug, 2004
Spire track level meter never falls to zero db with Shaper activated and mixed into signal.
Disabling Shaper or set the mix level to zero fixes the issue until the first note is playing. Then the issue comes to live again. This happens in Tube 1 mode only
Disabling Shaper or set the mix level to zero fixes the issue until the first note is playing. Then the issue comes to live again. This happens in Tube 1 mode only
- KVRist
- 422 posts since 10 May, 2009
Please send all information about your setup to support@reveal-sound.com.
Thanks!
Thanks!
- KVRer
- 29 posts since 28 Dec, 2017 from Brisbane, Australia
I have sent through my own repro of the issue (as described above).
Edit 1: Spire 1.5.9 still exhibiting the same issue today. However, found that the signal was at around 20Hz, so a steep highpass filter worked around the issue.
Edit 1: Spire 1.5.9 still exhibiting the same issue today. However, found that the signal was at around 20Hz, so a steep highpass filter worked around the issue.
- KVRist
- 422 posts since 10 May, 2009
We confirm the issue.
Our engineers will do their best to find a delicate solution that does not affect the overall sounding.
Hope for your patience and understanding.
Our engineers will do their best to find a delicate solution that does not affect the overall sounding.
Hope for your patience and understanding.
- KVRer
- 29 posts since 28 Dec, 2017 from Brisbane, Australia
Awesome - thanks.
- KVRer
- 29 posts since 28 Dec, 2017 from Brisbane, Australia
Thanks for the quick turnaround on the Spire release (1.5.10) to fix this issue. I haven't been able to replicate the issue that was affecting me.