MSpectralDynamics. Bad resolution at high frequencies.
-
- KVRist
- Topic Starter
- 199 posts since 2 Jan, 2003
Hi, please have a look at the attached image. It's a plain saw wave going into MSpectralDynamics. As you can see the plugin doesn't present harmonics above 1 kHz, correctly. First, I thought it's a graphic error but unfortunately it's not just that. If you check a spectrum on MMultiAnalyzer (which is located after MSpectralDynamics in the plugin chain), you'll see what MSpectralDynamics is actually doing in this test:
1. It reduces harmonics at the low freq. range leaving the ones higher than 1kHz untouched.
2. You can also notice how uneven the reduction is between harmonics.
3. The reduction graph on MSpectralDynamics doesn't reflect some reduced harmonics.
Are these somethings that can be improved?
Any chance for a min-phase version?
Cheers,
Vitaly.
1. It reduces harmonics at the low freq. range leaving the ones higher than 1kHz untouched.
2. You can also notice how uneven the reduction is between harmonics.
3. The reduction graph on MSpectralDynamics doesn't reflect some reduced harmonics.
Are these somethings that can be improved?
Any chance for a min-phase version?
Cheers,
Vitaly.
You do not have the required permissions to view the files attached to this post.
-
- KVRist
- 212 posts since 9 Dec, 2014
It is due to the smoothing of the peak values.
I agree that an "Analytical smoothing" would be a great addition, like in MAnalyzer... so that each peak represents a real peak level, even if it is smoothed.
I agree that an "Analytical smoothing" would be a great addition, like in MAnalyzer... so that each peak represents a real peak level, even if it is smoothed.
-
- KVRist
- Topic Starter
- 199 posts since 2 Jan, 2003
- KVRist
- 231 posts since 17 Apr, 2013 from Sverige
I wouldn't mind hearing something about this from Melda reps. Thanks for taking a dive into it, Vitaly.
Reaper | MComplete Bundle