I was playing around with the electric guitar the other day. Using the position switch gives you a bunch more tones but if I put it to say position 12 and then play for a little bit, maybe only a few notes away, after a few seconds the sound goes back to the default position tone, although K4 still shows it as being in position 12. I hope I'm making sense.
What's up here?
Evolution electric question
-
- "The" Jazz
- 4560 posts since 18 Aug, 2004 from California, United States
Just a guess at what might be going on...
Make sure that when you edit the position, you're on the default layer. Just a guess, but if you're on another layer, the position will only be set when that layer is triggered. So unless you want to set up a keyswitch or controller that changes the fretting position, just set the position while the layer knob is on "default".
Make sure that when you edit the position, you're on the default layer. Just a guess, but if you're on another layer, the position will only be set when that layer is triggered. So unless you want to set up a keyswitch or controller that changes the fretting position, just set the position while the layer knob is on "default".
Greg Schlaepfer
Orange Tree Samples
Ultra-realistic sample libraries for Kontakt
Orange Tree Samples
Ultra-realistic sample libraries for Kontakt
