Hey all, my first post here - so thanks to Urs for all the amazing work with Zebra, and thanks to all the people providing helpful tips and knowledge here at KVR.
So - is there a way to turn Active Modules in the Grid 'On' (Active) or 'Off' via Automation or MIDI control from Logic (7.2.1/Mac)?
I have OSC1 running through Grid Channel 2 and OSC2 running through Grid Channel 3, BUT - each OSC also goes through a Shaper (Shape1 and Shape2).
I want to turn Shape1 and Shape2 'Off' for the 'Intro' and then turn them 'On' for the 'Verse'...
Make sense? Any clues?
Thanks again - lovin' the Zebra.
Turn Grid modules on/off via Logic?
-
- KVRer
- 4 posts since 8 Aug, 2006 from London
-
- u-he
- 30248 posts since 8 Aug, 2002 from Berlin
Sorry... the Grid is something that doesn't fit in the typical scheme of "parameter"... thus you can't automate it...
However, IIRC you can automate volumes of the Mixer... or better: Set up the XYs to control the different mixes and then have just 1 automation track (X1 or so) to control it all!
Cheers,
Urs
However, IIRC you can automate volumes of the Mixer... or better: Set up the XYs to control the different mixes and then have just 1 automation track (X1 or so) to control it all!
Cheers,
Urs-
- KVRer
- Topic Starter
- 4 posts since 8 Aug, 2006 from London
Thanks Urs,
Using the XY's did the trick - also let me automate a little volume drop on OSC1 and 2 to compensate for the increased volume when the Shapers kicked in.
Cheers
J
Using the XY's did the trick - also let me automate a little volume drop on OSC1 and 2 to compensate for the increased volume when the Shapers kicked in.
Cheers
J