TAL - Noizem4k3r release list...!

[Xenox.AFL]

TAL - Noizem4k3r Version 3.10 released

- 3 new filter types added (24db State Variable Filter, LP, BP, HP)
- Clicks while releasing note under some conditions fixed

http://kunz.corrupt.ch/products/tal-noisemaker

Frank

[Sendy]

I did wonder, the new SV BP is very quiet, and in all three of the new SV filters, the resonance knob seems to have no audible effect in the first half of it's travel. This seems a bit strange, but not a huge deal, so I'm pointing it out.

[Xenox.AFL]

TAL - Noizem4k3r Version 3.22 released

- Audio Unit now working in Logic Pro/Express (because version 3.21 wasn't working)
- Hanging Notes in same DAW's is fixed
- New feedback delay

http://kunz.corrupt.ch/products/tal-noisemaker

Frank

[Teksonik]

Frank, a question if I may. How does one assign the Mod Wheel to Vibrato? The LFO's Amount knob goes -1 to +1 and I can't figure out how to get the Mod Wheel to just go from 50% (dead center) to +1 (or less than +.25 more likely)....instead it goes the whole sweep from -1 to +1 so I'd have to keep the MW at center to have no Vibrato. There must be a simple solution? I've checked a few of the lead patches in the default bank and found no Vibrato programmed in any of them... Thanks.