Exact values

[MacFluffers]

Hey, I'm looking at an LFO module on my poly synth, and I've set the frequency to 1.01 cpb. However, I want it to be 1.00, so that it stays with the beat. Is there a way to change the values of...well, everything that has a knob, other than turning the knob? The knob isn't as precise as I'd like.

Same thing with the rack sliders, actually. It's hard to get something at the particular decibel level I want.

[pljones]

Double click the label and type the number in for anything with such a label. Rack sliders... mmm... don't know if that one's possible...

[MacFluffers]

It doesn't work. :/

I know that works for a lot of things, but it doesn't work on everything, including unfortunately the modules in the custom synth.

[AndreasD]

Try adjust with holding down CNTRL.
Mousewheel works e.g. on rack faders with a 0.25dB increment. With CNTRL it's 0.01dB increment.
Similar thing with any other knob.

[MuTools]

You can also [Alt]+click on knobs and sliders, this will set the value to various preset positions.

Cfr http://www.mutools.com/mulab/docs/gui-info.html

That said, there is a note on the wishlist about double-clicking the parameter value so you can enter a specific value by text. Not an easy thing though, especially for non-linear parameters.

[plutonia]

aha, been wondering bout this;getting pan positions back to centre has been annoying me but just noticed in docs can get default values using 'ctrl' and 'alt'!

[MacFluffers]

Ah, these commands are useful to know. Thank you very much.

[Reincke]

That said, there is a note on the wishlist about double-clicking the parameter value so you can enter a specific value by text.

Would be great for netbook users like me. I often wished that.