KVR Audio

Ultrabra · Post by **Ultrabra** » Tue Apr 03, 2012 7:35 pm

Is it possible to record in realtime into my DAW (Sonar X1) parameter changes in Zebra - eg, changing for example cut off whilst an arp plays back?

Examigan · Post by **Examigan** » Tue Apr 03, 2012 7:48 pm

Ultrabra wrote:Is it possible to record in realtime into my DAW (Sonar X1) parameter changes in Zebra - eg, changing for example cut off whilst an arp plays back?

Yes, it should work if you click the W in the top-right cornet of the synth's window. Click it, then start playback of your song, adjust the cutoff while it's playing, then after the song is done, uncheck the W, and play it back.

It should have recorded the cutoff amount for you.

danbroad · Post by **danbroad** » Tue Apr 03, 2012 7:48 pm

Yes. Have a hunt around for 'automation'. Have you got the Zebra manual? It's quite helpful. Failing that, ask at the Cakewalk forum for advice.

Ultrabra · Post by **Ultrabra** » Tue Apr 03, 2012 7:56 pm

Thanks - I don't see a W Write button on my Zebra --- I see now from the PDF manual it should be in the top left. Maybe this is because its a demo version still?

Ultrabra · Post by **Ultrabra** » Tue Apr 03, 2012 8:05 pm

Got it to work now - but only in the 64 bit version of the demo. The 32 bit version didn't have the R and W buttons.

Examigan · Post by **Examigan** » Tue Apr 03, 2012 8:33 pm

Ultrabra wrote:Got it to work now - but only in the 64 bit version of the demo. The 32 bit version didn't have the R and W buttons.

I have Producer 8.5, and it may be a bit different in the X1

Recording Zebra parameter changes in realtime in DAW