how would i do this in FLstudio 4.5.2 ???

[Jaeson Merrill]

(a copy of my post from looptalk)

Jaeson the Merrill wrote :


I would like to link the tempo, and the dynamics control on BFD to the peak amplitude on the master....

in other words, as the song gets louder, the tempo gets faster (only with a width of about 5 bpm), and the DYN control on BFD (how hard the drummer plays (again, with a marginal width, not extreme) increases.

and conversely of course, as it gets softer, the tempo slows and the dynamics go down or back to normal.



is there a way to program this???

if someone could show me how it would increase my knowledge ofthe different internal controllers in FL

i read the manual, but havent gotten anywhere wit this.



thx

figgered some of you kvr demousers may know

[The Chase]

You could link the tempo to be controlled by the same knob that you would link the volume to. You would create the knob in the dashboard.

[dougsyo]

I'd probably try a Fruity Peak Controller to pick up the volume... but you'd almost need a "constant" signal (steady sine w ave) that increases in volume, but isn't routed to an output bus to make sure your tempo isn't "bouncing" with the peaks.

Then I'd like the BFD controls to the Peak Controller.

Doug