Hi! I recently upgraded to Speedrum 1.2.0, and suddenly I can't seem to change the outputs of pads any more. The output dropdown simply does nothing. (Previously set outputs in old projects still seem to be correct, though. Just can't be changed...) I tried downgrading back to 1.1.2, and setting outputs there seems to work fine.
I'm on Linux, host is Reaper.
Issue changing outputs in Speedrum 1.2.0
-
- KVRist
- Topic Starter
- 72 posts since 9 May, 2006 from Finland
Artist name Ben Enkindle. I make electronic music with Linux software.
-
- KVRist
- 299 posts since 19 Aug, 2020 from Earth
Do other menus (Trigger, Cut, etc) respond normally?
Is that also happening with the new instance of the plugin?
Is that also happening with the new instance of the plugin?
-
- KVRist
- Topic Starter
- 72 posts since 9 May, 2006 from Finland
It did seem like other menus worked. I tried both restarting the DAW and using a new instance and that didn't seem to have an effect.
At one point the output menu did actually appear to work for a little while, but after I closed and re-opened the plugin, it wasn't responding again, so I have no idea how or why that happened...
At one point the output menu did actually appear to work for a little while, but after I closed and re-opened the plugin, it wasn't responding again, so I have no idea how or why that happened...
Artist name Ben Enkindle. I make electronic music with Linux software.
-
- KVRist
- 299 posts since 19 Aug, 2020 from Earth
-
- KVRist
- Topic Starter
- 72 posts since 9 May, 2006 from Finland
Debian testing 64bit, Gnome 41.1.
Artist name Ben Enkindle. I make electronic music with Linux software.
-
- KVRist
- 299 posts since 19 Aug, 2020 from Earth
-
- KVRist
- Topic Starter
- 72 posts since 9 May, 2006 from Finland
Would appear to be working now. Thank you!
Artist name Ben Enkindle. I make electronic music with Linux software.
