Mono to poly always gives error after rendering

[gentleclockdivider]

I've been making some mono to poly instanes and it works flawlesly ,
But in renoise after rendering a selection to sample , architect always gives an error in the mono to poly module , altough the rendered result is perfectly fine .
This is the inside of a mono to poly , it's 4 fourvoices but I give 8 id's in total to incoming notes , which means once the four voices are exceeded (holding down 5 notes ) , the fifth note is redirected to the first voice , the sixth to the econd etc..
I think the error comes from reoiseresetting the audio engine while rendering to selection and architect also resets automatically

[colin@loomer]

Could you put a [midi to tuple] > print before the [give note id] and see what messages Renoise is sending? Thanks.

[gentleclockdivider]

Hmm .to much to mention really , mostly same stuff

Here's the architect file , If you have time you can try it with the gforce sem demo ,saddly renoise demo does not let you render to selection