KVR Audio

dvdvelde · Post by **dvdvelde** » Sat Jan 29, 2005 10:34 am

I still would say , that BGtech had a full plugin version of BGtech Compressor Pack. But somehow they stopped working on it ? Yes . it's really a great plugin....

PeterL · Post by **PeterL** » Mon Jan 31, 2005 12:46 pm

ericj23 wrote:you can do this without monkeying about too much

quad bus

two stereo child channels

send to the second is the key

send to the first is the compressor

and it sounds good

Yes, this works very well and easy but it has its disadvantage, because since this is an output bus you are at the end of the routing-chain (no more further routing possibilites to other groups etc.).

ericj23 · Post by **ericj23** » Mon Jan 31, 2005 1:01 pm

eh - quad buses don't have to be outputs (in sx3 anyway)

so i am not sure what you mean

PeterL · Post by **PeterL** » Mon Jan 31, 2005 1:08 pm

ericj23 wrote:eh - quad buses don't have to be outputs (in sx3 anyway)

so i am not sure what you mean

I din't know that. I don't have SX3 (still SX2, sniff

).
In SX2 you can only define In/Out-Busses as Quad-busses with child-busses.

Kingston · Post by **Kingston** » Mon Jan 31, 2005 1:17 pm

Are you sure you simply did make your quadbus the last bus on the list? If it's the last bus you can't route it to the previous ones. (Limitation due to the latency compensation)

Otherwise it can be routed to further busses.

PeterL · Post by **PeterL** » Mon Jan 31, 2005 1:27 pm

Kingston wrote:Are you sure you simply did make your quadbus the last bus on the list? If it's the last bus you can't route it to the previous ones. (Limitation due to the latency compensation)

Otherwise it can be routed to further busses.

Maybe you are right. I have to test it again tonight if routing a bus to another bus is possible. Do we still talk about busses, not groups ?

hibrasil · Post by **hibrasil** » Mon Jan 31, 2005 2:00 pm

i will try and make a sidechaining compressor in Max/pluggo that has a seperate plugin for the sidechain input. should be much simpler to use.

oli

PeterL · Post by **PeterL** » Tue Feb 01, 2005 9:45 am

PeterL wrote:
Kingston wrote:Are you sure you simply did make your quadbus the last bus on the list? If it's the last bus you can't route it to the previous ones. (Limitation due to the latency compensation)

Otherwise it can be routed to further busses.
Maybe you are right. I have to test it again tonight if routing a bus to another bus is possible. Do we still talk about busses, not groups ?

This doesn't work (at least in SX2). You can route groups to other groups, but not output-busses to other output-busses. Maybe there's an improvement in SX3.
Anyway, I updated my (detailed) desription here:
http://www.kvraudio.com/forum/viewtopic.php?t=72851

Sidechains in Cubase