For those of you familiar with my simple frequency divider plugins, think of Schematic as the 8 channel "PRO" version.
SchematEQ is the same design but with all 8 dividers summed to a single stereo output. Whats this mean? A stereo frequency utility & EQ like no other..
Info -
Schematic for (semi)-Modular hosts
Download
Features.
- 100% Phase/Time aligned frequency divider.
- 8 stereo independent bands
- Gain/Attenuation & Mute for each band.
- I/O = 2in - 8out
————————————————————————-
SchematEQ
Download
Features.
- 100% Phase/Time aligned frequency divider.
- 8 stereo independent bands
- Gain/Attenuation & Mute for each band.
- I/O = 2in - 2out
This dosen't function at all like your goto EQ inside or out. If you follow the diagram from the bottom up you see the signal splits and you end up with 8 Bands. Each horizontal box 1/2's the frequency it receives & the slider adjusts the crossover/divide point. Above the 8 bands you will find a mute & volume pot. I recommend you stick to the top main 8 bands until you get the hang of it.
(Tip - remember the frequency range of each horizontal box gets split in half and sent to the box above it. So say you set the bottom box to split at 1000hz the above box to the left will receive 1000hz down. You will have to keep in mind that the box is only dealing with 1000hz down & that it will do no good to bring the slider past 1000hz. Each slider can handle 20-20,000 Depending on samplerate.)
Ok have fun with this beast of a thing.
