has anyone noticed this?
i take a basic loop, line up the onsets nicely, slice by onset, then slide to drum machine (bounce & slice)...
and the clip that is produced has audible clicks and pops....
now, if i open up the editor, i can see that it actually created a few slices that were just blips, but after deleting those, i'm still picking up pops and clicks.
is the feature simply not that robust?
thanks!
Clicks & Pops when Slice To Drum Machine
-
- KVRian
- 841 posts since 6 Nov, 2004 from UK
Hey Deblee, I use the slice to drum machine quite often and dont have any issues... i would suggest that you skip the 'slice by onset' step (if you're doing what i think you're doing) ... so the procedure would be:
take loop
line up onsets nicely
select 'slice to drum machine' (and inside the following dialogue box ensure that "slice at" is set to ONSETSs.)
and that's it.
Should be fine? let me know
take loop
line up onsets nicely
select 'slice to drum machine' (and inside the following dialogue box ensure that "slice at" is set to ONSETSs.)
and that's it.
Should be fine? let me know