effect routing on 404
-
Muon Software Ltd Muon Software Ltd https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=89
- KVRian
- 1461 posts since 21 Nov, 2000
Since DS404 doesn't have any built in FX, you'll have to do it in your host program.
If your host program supports VSTi's with multiple outputs, just route the channel you want to treat seperately to an output by itself (in the mixer screen) and set up the FX on that channel only in your host. If your host doesn't support multiple outputs (some don't) you won't be able to use this feature.
If you're not sure about how to use DS404's multiple outputs, refer to your user manual.
Hope this helps
Dave
If your host program supports VSTi's with multiple outputs, just route the channel you want to treat seperately to an output by itself (in the mixer screen) and set up the FX on that channel only in your host. If your host doesn't support multiple outputs (some don't) you won't be able to use this feature.
If you're not sure about how to use DS404's multiple outputs, refer to your user manual.
Hope this helps
Dave
-
- KVRian
- Topic Starter
- 533 posts since 15 Jul, 2003 from costa rica / oregon
well, i'm using fl and i believe i've been able to do this with other plugs like cm 505.
when i go to the mixer page, i find that all the samples are linked to channel 1, and i don't see any options to change that anywhere.
i'm also pretty sure that i read the whole ds404 manual, and i couldn't find any specific instructions there. in fact, the whole manual is very much like an essay about how great the plug-in is, but it doesn't really teach....
but maybe i'm totally wrong.
anyway, if anyone could explain how to do this (or post a link to a tutorial), i'd very much apreciate it.
::B::
when i go to the mixer page, i find that all the samples are linked to channel 1, and i don't see any options to change that anywhere.
i'm also pretty sure that i read the whole ds404 manual, and i couldn't find any specific instructions there. in fact, the whole manual is very much like an essay about how great the plug-in is, but it doesn't really teach....
but maybe i'm totally wrong.
anyway, if anyone could explain how to do this (or post a link to a tutorial), i'd very much apreciate it.
::B::
paz por esos mundos
-
- KVRian
- 1112 posts since 17 Jul, 2003 from Kauai, HI
If I remember correctly, there are six (?) tiny buttons next to the sliders on the mix page. The top one represents the first out, etc.
Tom
Tom
-
Muon Software Ltd Muon Software Ltd https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=89
- KVRian
- 1461 posts since 21 Nov, 2000
Section 9, Page 16. Dunno how you could have missed iti'm also pretty sure that i read the whole ds404 manual, and i couldn't find any specific instructions there.
Regards
Dave