Having a bit of an issue here
I have a dial ( rotary x) that controls the freq of four vst instances at the same time.
I also have a data table to further offsetting those values ( instance 2,3,4)
Issue I am having is I want to reset the se ofset values to the value which rotary x is currently at without calling rotary x .
Seems that rotary x into memory store- load is the only option .
Are there any others ?
Which brings me to the next question , the mem store and load will have to be in different macros and I recently found out that this does not work for data send receive modules .
Retrieve value without calling
-
gentleclockdivider gentleclockdivider https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=203660 - KVRAF
- Topic Starter
- 6113 posts since 22 Mar, 2009 from gent
Eyeball exchanging
Soul calibrating ..frequencies
Soul calibrating ..frequencies
-
gentleclockdivider gentleclockdivider https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=203660
- KVRAF
- Topic Starter
- 6113 posts since 22 Mar, 2009 from gent
Hmmm , now that I think about it , I could make an additional routing for the master cutoff to any module I like , math multi by 1 or latch , since they all temp.store values .
Then trigger it , make an array and put into the table , send to voice 2-3-4 .
Then trigger it , make an array and put into the table , send to voice 2-3-4 .
Eyeball exchanging
Soul calibrating ..frequencies
Soul calibrating ..frequencies
