LinPlug

pschelfh · Post by **pschelfh** » Mon Feb 03, 2014 10:12 am

Just tested Crx4 last weekend.

Something I noticed when using the 'Loop Sampler' oscillator : if you load a looped sample (I tested with my own samples) and use a long release time (3/4 of the knob) on the amp envelope, the sample doesn't loop anymore. It just plays until the sample end and then stops.

It seems that as long as you hold a key, the sample loops normally, but when you release a key, the sample no longer loops.

Is there a way to change this behaviour inside Crx4?

This is the 64-bit version on a PC with Cubase 7.5

Peter.

Philippe Favré · Post by **Philippe Favré** » Tue Feb 04, 2014 11:50 am

Hi Pschelfh
Here LoopSample Loops endless in release phase...

Philippe

pschelfh · Post by **pschelfh** » Tue Feb 04, 2014 11:58 am

Hi Philippe,

Strange, I will try with one of the factory samples to see if it loops after key release.

Peter.

Philippe Favré · Post by **Philippe Favré** » Tue Feb 04, 2014 3:33 pm

Dear Pschelfh,

Let me ask you this question:
have you really seen the " Re-Lo" button at the left of the scale filter?
Push it to GREEN and release loops now ad libitum ...
I hope to help you !

Philippe

pschelfh · Post by **pschelfh** » Tue Feb 04, 2014 4:03 pm

Thanks for the tip!

I will make sure it's green and save that as my init patch.

Peter.

Peter from LinPlug · Post by **Peter from LinPlug** » Tue Feb 04, 2014 6:18 pm

Thank you Philippe

LinPlug

KVR Audio

Crx4 key release - no loop