KVR Audio

almazmusic · Post by **almazmusic** » Sun Feb 23, 2014 5:06 pm

Chad@PA wrote: The only method that seems to work is to copy an installation from OS X 10.6 to 10.7 or above.

And where I can get it?

Chad@PA · Post by **Chad@PA** » Sun Feb 23, 2014 5:11 pm

almazmusic wrote:
Chad@PA wrote: The only method that seems to work is to copy an installation from OS X 10.6 to 10.7 or above.
And where I can get it?

Other Rapture OS X folks I've assisted with getting Rapture working usually found an older computer or friends computer to install to. Then copied that working installation over to their computer. Good luck.

FLWrd · Post by **FLWrd** » Sun Feb 23, 2014 6:50 pm

Any suggestions as to what files to copy? I do have an old G4 on which I could install Rapture, but after copying the all the pref files to my 10.8 machine, the installer still was throwing tantrums.

cyberheater · Post by **cyberheater** » Sun Feb 23, 2014 7:08 pm

aMUSEd wrote:OK I worked out an easier method. All you need is a working (legit) copy of the two plist files that go in preferences, edit them with your own serial and put them in preferences. This tricks the installer into thinking it is just updating an existing installation so it bypasses the serial entry problem (that was the bit not working as the regserver routine was not Intel based). I have tried this with Rapture and it is now installed - I just need someone with a legit copy of Dimension Pro on Mac to kindly send me copies of these 2 files for Dimension (I will gladly provide evidence that I am a legit owner if you want). Thanks

Annoying that there is very little Cakewalk need to do to make these run on OS-X Lion - they just need to pull their fingers out and do it

Can some kind soul PM me those two plist files with your serial number removed obviously.

I bought this software ages ago and have still not managed to install it.

Thanks.

FLWrd · Post by **FLWrd** » Mon Feb 24, 2014 8:37 am

I will give this a try one of these days...

FLWrd · Post by **FLWrd** » Mon Feb 24, 2014 6:48 pm

FLWrd wrote:I will give this a try one of these days...

Didn't work. I installed it on my G4 iBook, where it runs, copied the plist to my 10.8 machine, same error messages, and everything says "not installed properly".

maxadax · Post by **maxadax** » Mon Jun 02, 2014 9:45 am

Hi, is Chad still around? If so could you please send me the instructions as well. I've been trying to get it working for a while now and it would be nice to finally be able to install it.

Thank you

Rapture won't install on OS-X Lion