Discussion of Ozric Tentacles’ use of delay.
-
- KVRist
- Topic Starter
- 186 posts since 15 May, 2001
Hi Vurt. Yes, I am interested in the main sound of that tune that starts around 0:44 goes to about 5:04 and then starts again around 7:08. 1) What vsti is that? The pads sound like absynth, so is it absynth? 2) Are you playing with the cutoff by hand, if not what are you using? 3) What delay are you using on it and what delay settings? 4) What arpeggio pattern is it and at what tempo? Is it a 3 note arpeggio at a fast tempo? I can’t tell. Hope you will reply.
-
- addled muppet weed
- 111283 posts since 26 Jan, 2003 from through the looking glass
i will reply yes
but i cannot have a look at this moment
give me a few hours and ill have it sorted
glad you enjoyed the track,and it shouldnt be too expensive to recreate
no absynth here yet
but i cannot have a look at this moment
give me a few hours and ill have it sorted
glad you enjoyed the track,and it shouldnt be too expensive to recreate no absynth here yet
-
- KVRist
- 159 posts since 18 Jan, 2004 from Portland, OR
to answer tconrardy question about ozric and soft synths...
No, they like using hardware, as they believe the high registers of hardware can not compete with software. Its argueable, but I won't since they obviously know what they are doing!
Hopefully i'll be able to make it to the Chicago show!
No, they like using hardware, as they believe the high registers of hardware can not compete with software. Its argueable, but I won't since they obviously know what they are doing!
Hopefully i'll be able to make it to the Chicago show!
-
- addled muppet weed
- 111283 posts since 26 Jan, 2003 from through the looking glass
1) What vsti is that? The pads sound like absynth, so is it absynth?
pads are oddity
but the delayed plucky bit is ppg wave,using one of scot solidas tangerine dream patches
2) Are you playing with the cutoff by hand, if not what are you using?
using orions built in platinumphaser at a slow speed high phase
3) What delay are you using on it and what delay settings?
again orions own x delay times 2 set at 75%feed back
4) What arpeggio pattern is it and at what tempo? Is it a 3 note arpeggio at a fast tempo?
arperr is built into ppg patch,and bpm is at ninety
any other questions let me know
if you have the above vsts and can get hold of the orion platinum demo you can get the sfs off me and have a look
pads are oddity
but the delayed plucky bit is ppg wave,using one of scot solidas tangerine dream patches
2) Are you playing with the cutoff by hand, if not what are you using?
using orions built in platinumphaser at a slow speed high phase
3) What delay are you using on it and what delay settings?
again orions own x delay times 2 set at 75%feed back
4) What arpeggio pattern is it and at what tempo? Is it a 3 note arpeggio at a fast tempo?
arperr is built into ppg patch,and bpm is at ninety
any other questions let me know
if you have the above vsts and can get hold of the orion platinum demo you can get the sfs off me and have a look
-
- KVRist
- Topic Starter
- 186 posts since 15 May, 2001
Thanks!
-
- addled muppet weed
- 111283 posts since 26 Jan, 2003 from through the looking glass
think againDeranger604 wrote:to answer tconrardy question about ozric and soft synths...
No, they like using hardware, as they believe the high registers of hardware can not compete with software. Its argueable, but I won't since they obviously know what they are doing!
check camel audio forum
i have something in common with the ozrics
