Hi there,
ECS seems to be too easy for me.....
I am trying to set up the rotary so it switches from slo to fast by modWheel action.
MW 0 -> slow
MW 100% -> switch to fast
I managed to get it switched to fast but cannot figure out the other half.
I am able to do that on SampleTanks organ but i would like to do that with DaOrgan as well.
Any suggestions?
Regards
Marc
Latest News: LinPlug updates Spectral to v1.3
Organ3 and rotary
-
- KVRist
- Topic Starter
- 94 posts since 19 May, 2005
-
Peter from LinPlug Peter from LinPlug https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=24
- KVRian
- 1258 posts since 25 Oct, 2000
Hi Marc,
when assigning any CC (including Mod Wheel) you can switch Slow -> Fast and Fast -> Slow with it, I double checked and its fine. There is only one thing worth noting (from the manual:)
NOTE: When using ECS to automate the Slow/Fast switch make sure to use a “Switch” type Controller to actually switch between Fast and Slow using the Acceleration parameter. If you apply a “Continuous” type Controller like a dial or slider, the speed will adjust exactly as you move the Controller (ignorning the Acceleration parameter)!
Hope this helps,
Peter
when assigning any CC (including Mod Wheel) you can switch Slow -> Fast and Fast -> Slow with it, I double checked and its fine. There is only one thing worth noting (from the manual:)
NOTE: When using ECS to automate the Slow/Fast switch make sure to use a “Switch” type Controller to actually switch between Fast and Slow using the Acceleration parameter. If you apply a “Continuous” type Controller like a dial or slider, the speed will adjust exactly as you move the Controller (ignorning the Acceleration parameter)!
Hope this helps,
Peter