Controls when using Triangle waveform in BioTek 2
-
- KVRAF
- Topic Starter
- 7756 posts since 15 Sep, 2005 from East Coast of the USA
This is probably something I missed in the manual for BioTek 2, but when I load the "TY Default" instrument and then switch the first oscillator to a triangle waveform, there are no controls over to the right like when the saw, pulse, and the other types are selected. Not even a Level control is there.
But then I loaded the "Lead Sine-Triangle", and there are the controls on the screen over to the right for the 3rd oscillator (it uses the triangle). I am guessing it may be some other more complicated part of BioTek 2 that I just haven't gotten to yet.
But then I loaded the "Lead Sine-Triangle", and there are the controls on the screen over to the right for the 3rd oscillator (it uses the triangle). I am guessing it may be some other more complicated part of BioTek 2 that I just haven't gotten to yet.
-
Wolfram Franke Wolfram Franke https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=222340
- KVRist
- 79 posts since 25 Dec, 2009 from Germany
Hi Examigan,
good catch! Will be fixed in the next version. Sorry for the inconvenience.
Best wishes,
Wolfram
good catch! Will be fixed in the next version. Sorry for the inconvenience.
Best wishes,
Wolfram
-
- KVRAF
- Topic Starter
- 7756 posts since 15 Sep, 2005 from East Coast of the USA
No worries!Wolfram Franke wrote:Hi Examigan,
good catch! Will be fixed in the next version. Sorry for the inconvenience.
Best wishes,
Wolfram
I think it might just be the first oscillator with that issue, as you can see from these two screenshots:
You do not have the required permissions to view the files attached to this post.
-
Wolfram Franke Wolfram Franke https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=222340
- KVRist
- 79 posts since 25 Dec, 2009 from Germany
It *is* only the first oscillator and I have already fixed it locally. A new version will be released shortly.
Wolfram
Wolfram