So i´ve hooked up a simple ensemble, knob->controller in Reaktor. Putting a midi monitor vst behind Reaktor shows that when turning the knob within Reaktor only 3-5 messages are created on a full sweep. If i move the linked parameter from Bitwig´s Reaktor device the full sweep is shown. This is not the case with Reacontrolmidi, which i used so far.
The same ensemble works fine standalone and in REAPER.
Has anyone run into this yet?
CC from Reaktor
-
- KVRian
- 818 posts since 18 Oct, 2014
-
- KVRian
- Topic Starter
- 818 posts since 18 Oct, 2014
To elaborate here´s some screenshots:
The .ens i made The output from the ens in Bitwig using Reaktor´s GUI, full sweep and back The output from the ens using Bitwig´s GUI, full sweep and back
The .ens i made The output from the ens in Bitwig using Reaktor´s GUI, full sweep and back The output from the ens using Bitwig´s GUI, full sweep and back
You do not have the required permissions to view the files attached to this post.
-
- KVRian
- Topic Starter
- 818 posts since 18 Oct, 2014
And a last one, with this setup it works as expected but cpu usage went through the roof:
(disclaimer: i ripped this from a collection of macros)
You do not have the required permissions to view the files attached to this post.
-
- KVRian
- Topic Starter
- 818 posts since 18 Oct, 2014
Bump