help sx3.1 with pc and motu 828 firewire

[itsmedude]

hello
can you help i have recently installed the sx3.1 update since then have had problems with the midi ,i seem to have sorted the most problems out ,however the midi still seems a little out.
i have small time delay
i put on system time stamp
i put off system time stamp
where does the ignore port filter and enable emulated go
what is the exact time delay compensation supposed to be set @ ,if any is needed
,if anyone has fixed these problems could you reply i would be gratefull thanks
dude
also done a test and it says thers a 17421 delays in samples seems high

[JonathanDragonDJ]

is you're midi problem with note's you've programmed
or is it just when you play ur midi controller?
if the latter
you prolly just need to reset the latency lower
of the former...possibly needs to be higher to avoid the skipping

[itsmedude]

no with recording programmed ok

seems to be half a beat early at 130 bpm

is you're midi problem with note's you've programmed
or is it just when you play ur midi controller?
if the latter
you prolly just need to reset the latency lower
of the former...possibly needs to be higher to avoidthe skipping