Is it possible to apply an effect only to the wet signal of another effect?
For instance: say I had a signal going though some reverb (or delay) and I wanted to apply some chorus only to the wet signal coming out of that reverb (or delay), leaving the dry mix of the reverb/delay chorus-less. Is this possible?
Complex effects mapping in FLStudio?
-
- KVRAF
- 10597 posts since 13 Jun, 2004 from Alberto Balsam
-
- KVRist
- 205 posts since 25 Feb, 2005 from Germany
Yes. Put the reverb in a send track and place the chorus below it. Then just direct part of the signal coming out of the original mixer track to the send track using the associated send wheel. This way, part of the signal coming out of the original mixer track will processed by the reverb-chorus combination in the send track, whereas the other part slips through unchanged, ie. it's dry. So in the end, the chorus effect only processes the signal coming out of the reverb, ie. the wet signal.
If you'd rather have the reverb-chorus effect applied somewhere in the middle of the original mixer track and not at the end, then don't use the send wheel but put a send plugin in the middle of the track to direct part of the signal to the send track.
If you'd rather have the reverb-chorus effect applied somewhere in the middle of the original mixer track and not at the end, then don't use the send wheel but put a send plugin in the middle of the track to direct part of the signal to the send track.
Last edited by moppel on Sun May 08, 2005 4:58 pm, edited 1 time in total.
-
- KVRian
- 1256 posts since 22 Aug, 2003
Yes, of course it's possible!
Here's the FX list on the channel:
Fruity Send
Reverb
Chorus
Where Send sends the dry signal to a Send and the Reverb is set to 100% Wet.
I hope FL 6 has all mixer channels be able to be "sent" to, like you can with Sends. Something like energyXT is the best choice for this, by the way - the beauty of doing it with energyXT is that (1) it's fun/cool/modular/much more powerful than FL's semi-powerful routing and (2) you can load energyXT as a VST effect! So it does all of what I mentioned all in one. I need to try that...
Here's the FX list on the channel:
Fruity Send
Reverb
Chorus
Where Send sends the dry signal to a Send and the Reverb is set to 100% Wet.
I hope FL 6 has all mixer channels be able to be "sent" to, like you can with Sends. Something like energyXT is the best choice for this, by the way - the beauty of doing it with energyXT is that (1) it's fun/cool/modular/much more powerful than FL's semi-powerful routing and (2) you can load energyXT as a VST effect! So it does all of what I mentioned all in one. I need to try that...
-
- KVRist
- 205 posts since 25 Feb, 2005 from Germany
Well, Rellik's approach is even better. 
-
- KVRAF
- Topic Starter
- 10597 posts since 13 Jun, 2004 from Alberto Balsam
-
- KVRist
- 261 posts since 24 Jul, 2002 from Tennessee
Looks like I'm too late... But here's an example anyway:Chase Altertone wrote:Awesome! thanks, guys!
http://www.geocities.com/jesse_wade/FL/ ... Reverb.htm
By the way, chorus is about the most boring effect to put on reverb. Try a flanger or phaser...
-
- KVRist
- 205 posts since 25 Feb, 2005 from Germany
And more cowbell!
-
- KVRAF
- Topic Starter
- 10597 posts since 13 Jun, 2004 from Alberto Balsam
