Hi,
I've recently been noticing that I've been having a problem where whenever I stop a sequence and go back to the beginning of the piece/sequence, the modulation wheel value goes down to 0 (CC#1). I don't know why this is happening, as I have not drawn any control message automation envelopes or recorded any modulation wheel movements. Right now, it's more of an annoyance than anything else, but I'd really appreciate any help I could get.
Thanks,
Ian
Logic Audio problems
-
- KVRist
- 191 posts since 2 Apr, 2002 from Cincinnati, OH
-
- KVRAF
- 2696 posts since 3 Aug, 2003 from Narnia
Hi Ian, yes... Logic will re-set all controllers on stop. But it is possible to turn this off somewhere in one of the menus - Options or something.
Sorry to be so vague but I'm not in front of my music PC now, so I can't check.
Have a look in the manual, it's there somewhere. I'll check it next time I get into my little studio and post again (next week sometime).
Sorry to be so vague but I'm not in front of my music PC now, so I can't check.
Have a look in the manual, it's there somewhere. I'll check it next time I get into my little studio and post again (next week sometime).