KVR Audio

midwaydj · Post by **midwaydj** » Fri Jun 10, 2005 5:03 pm

I have a demo version of 2.4 and I was wondering if the spectrum analyzer meter is supposed to reflect in realtime the changes I make? If I roll off some low end is it supposed to reflect the changes in real time on the spectrum graph?

Aleksey Vaneev · Post by **Aleksey Vaneev** » Fri Jun 10, 2005 5:19 pm

Sure, it should reflect the changes. However, with small EQ changes you may hardly notice any change on the graph.

midwaydj · Post by **midwaydj** » Fri Jun 10, 2005 5:48 pm

I have tried to make drastic EQ changes to see if it will reflect on the graph, however the graph always remains around the same level as if I made no changes. I can hear the changes I have made, but I still cannot see the results on the spectrum analyzer. Is there a setting or mode I have to select for this to work?

Aleksey Vaneev · Post by **Aleksey Vaneev** » Fri Jun 10, 2005 8:08 pm

First of all, set the spectrum speed to a higher value. Secondly, you may select a low-pass filter just to be sure it works: low-pass filter tuned to 100 or 200 Hz is reflected heavily on the spectrum analyzer.

In practice, using 1/3 spectrum analyzer resolution is easier than the 'full' one.

midwaydj · Post by **midwaydj** » Fri Jun 10, 2005 11:49 pm

Thanks Aleksey! It was just the speed! I should have checked that.

Aleksey Vaneev · Post by **Aleksey Vaneev** » Sat Jun 11, 2005 5:31 am

Sure, it is harder to notice changes when spectrum speed is low.

Frippertronix · Post by **Frippertronix** » Sat Jun 11, 2005 5:37 am

Aleksey Vaneev wrote:Sure, it is harder to notice changes when spectrum speed is low.

Aleksy, is there a detailed explanation anywhere about how the dynamic process of GlissEQ works, or is that secret? I know there is a transient emphasis, but how does GlissEQ respond differently to different program material? What exactly does the dyamic control do to change these responses?

Thanks much,
Dave

Aleksey Vaneev · Post by **Aleksey Vaneev** » Sat Jun 11, 2005 8:10 am

In the core, this process is a 'secret'. User's manual discusses it in deep enough detail for the actual work. Only reverse-engineer may need more details about it.

Frippertronix · Post by **Frippertronix** » Sat Jun 11, 2005 9:14 pm

Aleksey Vaneev wrote:In the core, this process is a 'secret'. User's manual discusses it in deep enough detail for the actual work. Only reverse-engineer may need more details about it.

I'm not a coder, but thanks anyway.

I like the plug.

Aleksey Vaneev · Post by **Aleksey Vaneev** » Sun Jun 12, 2005 5:50 am

Beginner GlissEQ question