KVR Audio

Battleguard · Post by **Battleguard** » Thu Jun 30, 2005 9:08 pm

Hey.. when I plug in my guitar to my comp and thru some program (eg. FL studio)I get the original sound AND the processed sound..

Is it possible to hear just the processed sound and not hear the original sound at all?

Battleguard

C00kie · Post by **C00kie** » Thu Jun 30, 2005 9:58 pm

Yeah, switch off the input monitoring feature!

Battleguard · Post by **Battleguard** » Thu Jun 30, 2005 10:44 pm

no

.. then it only gives me the unprocessed sound and that's the opposite of what I want.. maybe I wasn't clear enough..

If I load up Amplitube and a preset Lead.. I want to hear only the sound that goes through amplitube and comes out of it processed (distorted etc).. and I don't want to hear my original clean sound..

BattleGuard

Jesse J · Post by **Jesse J** » Thu Jun 30, 2005 11:02 pm

Yeah, switch off the input monitoring feature!

Battleguard · Post by **Battleguard** » Thu Jun 30, 2005 11:06 pm

I mean while I am playing.. not just when I'm recording..I just want to hear latent sound..

Was that clear?

BattleGuard

sonicfire · Post by **sonicfire** » Thu Jun 30, 2005 11:08 pm

have you checked your (windows)-mixer settings ?

C00kie · Post by **C00kie** » Thu Jun 30, 2005 11:09 pm

I think we understand you pretty well. You are monitoring (hearing) the inputs directly. This is normally an ASIO feature of your soundcard. Go to its control panel, and switch it OFF.

Battleguard · Post by **Battleguard** » Thu Jun 30, 2005 11:17 pm

So I turned the playback line in to mute and I think that did it.. I'm only hearing one sound.. thx a lot

Edit: yep, that was it.. after exiting I heard nothing.. so thx again

BattleGuard

How to just use the processed sound?