Few q's:
1. Is there a way to select more than one zone so you could for example apply stretch to all of them without selecting them each individually?
2. Is there a way to not have the CSR reverb come on automatically when you load it up?
3. I've been trying to get a hold of the Yellow Tools KeySwitch program but their site seems to be broken for that - it looks to be an answer for keyswitching accross channels in miroslav - has anyone tried that, it might be effective?
And Squids, thanks for the extra combis - they are very nice.
steve
Miroslav questions
-
- KVRist
- 233 posts since 10 Aug, 2004
-
- KVRAF
- 4692 posts since 28 Jan, 2003 from In these very interwebs
1. Not at the moment. If you want to apply Stretch to ALL the zones (ie, the whole instrument), simply deselect "zone" mode, and then enable Stretch.
2. You can save your preferred initialisation state as a combi (which makes loading it just a click away). Alternatively, you can save the setup as your sequencer's default startup project.
3. Sorry, I haven't used KeySwitch.
Hope that helps.
-Kim.
2. You can save your preferred initialisation state as a combi (which makes loading it just a click away). Alternatively, you can save the setup as your sequencer's default startup project.
3. Sorry, I haven't used KeySwitch.
Hope that helps.
-Kim.
-
- KVRian
- 1238 posts since 10 May, 2002 from Sweden
Haven’t tried it with Miroslav (just orderedsghoughton wrote:3. I've been trying to get a hold of the Yellow Tools KeySwitch program but their site seems to be broken for that - it looks to be an answer for keyswitching accross channels in miroslav - has anyone tried that, it might be effective?
) but it works fine with ST2 so there shouldn’t be any problem. Not sure what’s going on with the Yellow Tools website, maybe you should drop them an e-mail?/Yoss