KVR Audio

munkee · Post by **munkee** » Sat Oct 08, 2005 5:53 am

I have the Delta 1010 card. I have my monitors set to output 1/2 and headphons set to outs 3/4. I can't seem to get both outputs going simultaneously in these hosts.

Does anyone know of a way to get them both going at the same time. No matter how I set the outs they will only work one at a time.

bduffy · Post by **bduffy** » Sat Oct 08, 2005 6:01 am

Check if both stereo outputs show up in Devices/VST Connections. You should be able to assign track outputs and sends to those outs. If you have just one stereo Bus, add a bus there and select the 3/4 as the output. I assume you're ReWiring Reason to Cubase, so Reason should be irrelevant.

I'm just guessing here, but I work with similar setups. Good luck!

munkee · Post by **munkee** » Sat Oct 08, 2005 6:23 am

This is weird My first 6 out/ins show up as Delta 66 Then in/out 7-10 show as Delta 1010?

bduffy · Post by **bduffy** » Sat Oct 08, 2005 4:23 pm

OK, but can you output signal through any of them?

josevin2000 · Post by **josevin2000** » Sat Oct 08, 2005 6:03 pm

munkee wrote:This is weird My first 6 out/ins show up as Delta 66 Then in/out 7-10 show as Delta 1010?

Thtas ok..not a prob... in cubase, inside device setup, in vst inputs, simple rename the first 6 inputs to delta 10...

regarding monitoring i would suggest... Connect OP 1-2 to your monitors and 3-4 to our headphones... next in cubase or even reason give your main output to be Delta 10/10 Output 3-4 ( This is after u have renamed the first six output from delta 66 to delta 10/10 )

Now in the M-audio mixer, make sure Channel 3-4 output is goin to the monitor mixer.... and in the patchbay/Router section of the mixer, select Monitor mixer as the source for H/W Out 1/2.. try it and lemme know how it goes...

munkee · Post by **munkee** » Sat Oct 08, 2005 9:50 pm

All my other standalone instrumets work fine. As far as Reason goes it seems to only allow me one output at a time. At least when I turn the Reason Rack backwards(tab button) I can only go into one set of outputs at a time...Right??

munkee · Post by **munkee** » Sat Oct 08, 2005 10:13 pm

josevin2000!!! Thanks for the tips. My eyes have been a little off lately, But I figured out your configuration and that did it!! thanks to bduffy too!!

josevin2000 · Post by **josevin2000** » Sun Oct 09, 2005 5:53 am

yeah munke the method may seem complicated, but once u have it figured out, all your problems are solved...

Actually i too had a similar case, some couple of months ago and thats exactly how i patched my setup...

Cubase SX 3.1/Reason 3.0 Output question with Delta 1010