Can i assign a midi note to an "arranger" slice?

[lalo]

Hi guys,
is there a way to assign a midi note to play a single slice in the arrangement, so it will play with all its parameters (reverse, a, d, r, pitch etc...)

..then i'm not sure what about are the 2 midi paramters...the manual doesn't explain it very well

[ohm]

is there a way to assign a midi note to play a single slice in the arrangement

Not yet.

But I'm close to having that feature implemented so it will be in 1.2

I'm looking over the manual later today, I'll make sure to explain the midi stuff properly. Setting it up is host dependent, so you need to check the last section of the manual too, if you haven't yet

[lalo]

But I'm close to having that feature implemented so it will be in 1.2

cool

[ultima]

Hmmm....I might just need my morning coffee but i fail to say how to get audio from the slicer to the arranger ?

[ohm]

Don't despair, drag'n'drop is on the way Right now I use a more "mousepad friendly" solution: click a slice in the slicer and then click somewhere in the arranger. If an event is already there, the audio will be replaced, otherwise a new event is created where you click.