KVR Audio

Kraku · Post by **Kraku** » Sat Nov 05, 2005 6:51 pm

Where is it?

A3ntar · Post by **A3ntar** » Sat Nov 05, 2005 7:26 pm

Not on their release list, that's for sure.

eshbal · Post by **eshbal** » Sat Nov 05, 2005 7:41 pm

I can't wait any more! Where is it ?

Tony Ostinato · Post by **Tony Ostinato** » Sun Nov 06, 2005 7:42 am

its undeniably clever to release each alogrithm seperately, they could go on this way for years.

Kraku · Post by **Kraku** » Sun Nov 06, 2005 8:07 am

I quess Microsoft takes all their time now so they don't have the time to finish that VST Plate

eshbal · Post by **eshbal** » Sat Nov 12, 2005 6:48 pm

Yes! finally it's on their site and also the demo !

shamann · Post by **shamann** » Sat Nov 12, 2005 7:30 pm

Okay, so I downloaded the CR version of the Plate demo, assuming it would be the same copy protection that I have working with the Stereo Room.

The site says: You can choose to use Pace challenge/response copy protection. It does not require an iLok and does not install any kernel drivers on your system.

But, when I try to load the Plate demo, I get this error message:

Which, I'm afraid, is totally uncool by me. I guess saying it doesn't install kernel level drivers is technically correct, although a bit misleading considering you have to have them installed yourself. I await for PD to sort this out before I try. I'm wondering if they put the ilok one into the CR zip file?

arturmeinild · Post by **arturmeinild** » Sat Nov 12, 2005 11:14 pm

Finally... Does this clear up if the challenge/response system is the same for both the Stereo Room and the Plate? I would assume that a Pace CR system requires some drivers installed, as does the iLok, so I guess there is no way you can avoid it is there???

shamann · Post by **shamann** » Sat Nov 12, 2005 11:27 pm

The original version of the Stereo Room VST did not require the driver, but used a form of Pace C/R. I have it installed and working on my system. So sadly, nothing seems very clear at the moment.

Kraku · Post by **Kraku** » Sat Nov 12, 2005 11:32 pm

I have the same problem.

I just sent PD an e-mail and asked if the C/R uses the device driver afterall. I suppose it does't. This must be just a bug on their part. They probably compiled the plugin with wrong settings.

shamann · Post by **shamann** » Sun Nov 13, 2005 12:21 am

Very likely they put the iLok version in both zip files.

Funkybot · Post by **Funkybot** » Sun Nov 13, 2005 12:24 am

I had the same problem. Not sure what's going on with that. I hate to say it, but I think it may be time to just give into resisting and buy a damn iLok.

omo · Post by **omo** » Sun Nov 13, 2005 12:32 am

I didn't find their room any good, an average plug-in, imho. Never heard the plate unit from 80s but I doubt it's there on the level with EMT plates.

Kraku · Post by **Kraku** » Sun Nov 13, 2005 8:32 am

omo wrote:I didn't find their room any good

Heretic! Let's burn the witch!!!

steffensen · Post by **steffensen** » Sun Nov 13, 2005 10:19 am

Princeton Plate 2016 reverb!!!!