KVR Audio

cytrek · Post by **cytrek** » Wed Dec 07, 2005 9:36 pm

i want to use energy xt for sequencing vsti plugins but how do i do it inside audiomulch as my host?

adam standring · Post by **adam standring** » Sat Dec 10, 2005 3:51 am

Try using Midiyoke (from http://www.midiox.com/) to patch through from an eXT MIDI out to an Audiomulch MIDI in. Audiomulch will think of it as a MIDI input device, and I imagine you could even then sequence VSTi's open inside 'Mulch, which is not currently fully supported.

shamann · Post by **shamann** » Sat Dec 10, 2005 3:57 am

eXT opens as a VST plugin inside Mulch. Just load all synths inside eXT's sequencer. The sequencer will sync to Mulch's transport, and then you can map parameters of anything inside eXT to Mulch's automation. This way you'll have all the MIDI stuff going on inside eXT, and everything else working inside Mulch.

adam standring · Post by **adam standring** » Sat Dec 10, 2005 12:50 pm

shamann wrote:eXT opens as a VST plugin inside Mulch.

Oops! Forgot about that VST version - isn't eXT great? The VST version is still a bit unstable in some hosts at the moment though.

energy xt and audio mulch