KVR Audio

fliffo · Post by **fliffo** » Sat Dec 17, 2005 4:11 pm

I'd like to automate vst parameters via the amplitude of a given audio signal. The priciple is the same of sidechain compressing but wider.
I thought to something like a vst fx that receives audio and converts it to cc controller data, so if a vst parameter responds to that cc, you could control it.
This is just my idea, I don't know if there are other ways.
Does it exist a plugin for this pourpose?

P.s. I know that FL Studio has an internal controller like that, but I don't use FL anymore.

Sickle · Post by **Sickle** » Sat Dec 17, 2005 4:20 pm

There's a 'Some midi plugs' thread in the Energy XT support section of this forum that might be your best bet for finding what you are looking for. failing that, I would ask 'soma' if he knows of one that you can use.

Sickle · Post by **Sickle** » Sat Dec 17, 2005 4:21 pm

http://www.kvraudio.com/forum/viewtopic ... 25&start=0

Try not to get too distracted; there's some really good stuff in there..

plastique · Post by **plastique** » Sat Dec 17, 2005 4:24 pm

env2midi

(still worth it to go through the list at ext's forum)

fliffo · Post by **fliffo** » Sat Dec 17, 2005 4:41 pm

Yep! I've found soma's "Enveloper" plugin (is it loadable in Ext only??) and also smartelectronics "env2midi".
Will try to see what suits best!
thanks!

audio amplitude-->vst parameter modulation ??