KVR Audio

j_p · Post by **j_p** » Sun Feb 05, 2006 5:26 pm

"replacer" is a VST plug-in designed to replace drum and percussive sounds with other samples. Basically, it is comprised of a band-pass filter which selects the relevant frequency of the sound required to be replaced, and then the peak amplitudes at this frequency then trigger chosen sample/s. The samples can be 16 or 24-bit PCM Wave files recorded at any sample rate.

Features:

* 24dB band-pass filter
* Simple gate
* Visual and audio monitoring section
* 4 sample layers (full version)
* Sample start and end adjustment
* Accent amount and smooth (attempts to replicate the dynamics of the original trigger sound)
* Sample ADR envelope with amount control
* Sample pitch control

There are two versions available - "replacer ltd" is limited to one layer and is completely free; "replacer" has four layers and a donation is required. There is no minimum donation amount.

http://www.boxsounds.com/vst.html

Cheers,

Jez

j_p · Post by **j_p** » Sun Feb 05, 2006 8:53 pm

*cheeky bump*

deaf dunderkwac · Post by **deaf dunderkwac** » Sun Feb 05, 2006 8:59 pm

gra-tue-uh-tus
*bump*
will try this out,
thanks

j_p · Post by **j_p** » Mon Feb 06, 2006 12:48 pm

Thanks dunder - any feedback would be muchly appreciated.

deaf dunderkwac · Post by **deaf dunderkwac** » Mon Feb 06, 2006 3:53 pm

perhaps it's just my host burping, but it doesn't recognize the vst. Unfortunately, this does happen from time to time.

Making Waves Studio is the host.

sboullion · Post by **sboullion** » Mon Feb 06, 2006 8:12 pm

It's pretty buggy on my box, too. Using Samplitude. When it does work, however, it works pretty well.

novaflash · Post by **novaflash** » Mon Feb 06, 2006 9:16 pm

funny, i've built a similar project with SE too (but 4 voices), good luck for your release

eric

j_p · Post by **j_p** » Tue Feb 07, 2006 3:05 am

dunder -

downloaded the Making Waves demo to see what was up. It recognized the VST for me, but when I went into Track Files/Audio Effects/VST plug-ins the presets were in a folder called "container" - saw that I'd forgotten to initialize all the presets as well - these'll both be fixed in the next couple of days. Anyways, I got the plug-in working but I couldn't work out how to route it so the original audio cannot be heard.

sboullion-

downloaded the demo of Samplitude as well and it seemed to be working OK for me - could tell me what problems you were experiencing?

Thanks for the feedback guys.

eric-

nice one - thankyou very much

boxsounds "replacer" released - a drum replacer