KVR Audio

T-CM11 · Post by **T-CM11** » Fri Mar 31, 2006 11:58 am

In FL Midi setup I can select my MS20 controller as "MS-20" instead of "Generic".
What does this do? I still can't use all the knobs without asigning them all.
Also, I have to save this as a template if I don't want the repeat the knob-asignment again and again and again

So I can't simply add a MS20 plugin to a track and start twisting buttons

I also tried to make a midi out template, it memorizes the CC's, but not which knob uses which CC

mrcleva · Post by **mrcleva** » Fri Mar 31, 2006 9:02 pm

Same prob. I have with my Korg Kontrol49, it shows in the selection but no knob-asignment what so eva. Much as I love FL, I have finaly accepted FL studio is at the bottom of the Seq. chain (I can't believe I just said that!).

mrcleva · Post by **mrcleva** » Fri Mar 31, 2006 9:07 pm

Also you ever notice when reading hard/soft ware reviews & how they start describing whats compatible like Sonar 5, Cubase SX3, Live 5 & etc... Ever notice how they almost never say FL Studio!?!? See where I'm going, I'm in the process of learning Cubase SX3 and its like learning how to walk all over again. In the end I know it will be worth it tho, trust me I would brag about FL for days until folks just got tired of hearing about it. But just like having sex with Beyonce & Lil Kim (at the same time

) , I........Woke.......UP!!!! I'd advise you to do the same bro...FL got heart but not the strenghth

FL Studio 6.08 + MS-20 Legacy