KVR Audio

Centro · Post by **Centro** » Fri Apr 28, 2006 5:12 am

I have a bit of a problem with my pads ex. I would like to make 'em a little fattier but I still haven't found anything that would do so. Is there any good (and maybe free

) fatty available?

Centro · Post by **Centro** » Fri Apr 28, 2006 5:14 am

And if there has been answer for this earlier, gimme the link. Thank you

ouroboros · Post by **ouroboros** » Fri Apr 28, 2006 5:37 am

are you looking for an effect to place on your pads, or a different pad machine?

chimmy · Post by **chimmy** » Fri Apr 28, 2006 6:33 am

Try Camelphat

Centro · Post by **Centro** » Fri Apr 28, 2006 6:57 am

I'm trying to look for an effect to place on my pads. And I'll try CamelPhat.

ouroboros · Post by **ouroboros** » Fri Apr 28, 2006 7:30 am

camelphat will make them more "solid" -it's a compressor. You might want to try a chorus, say Kjearhus Classic Chorsu to "spread" the sound out. Of course, you could duplicate the synth part, pan each a bit left and right, not too much, and detune them from one another a few %'s - that will thicken the broth. Finally, you can add another identical track if you like, one octave lower, route all the signals to the same bus and eq out the real low bottom end.

Kriminal · Post by **Kriminal** » Fri Apr 28, 2006 7:39 am

chorus and EQ.

Centro · Post by **Centro** » Fri Apr 28, 2006 8:13 am

Thank you all.

VanLichten · Post by **VanLichten** » Fri Apr 28, 2006 8:37 am

Other Ideas: very short delays, layering synths.
Plug-in-wise: Audiodamage Discord.

Fatman!