KVR Audio

badnewsbearrec · Post by **badnewsbearrec** » Tue Jul 11, 2006 7:01 am

What has been happening lately is that all of my tracks and/or clips keep cutting out and cutting back in.

Now when I open my program...no matter what I open up starts to sound like it is extremely distorted and on tremelo/phaser mode.

Something is f**ked up, but cant pin it. Any suggestions?

badnewsbearrec · Post by **badnewsbearrec** » Tue Jul 11, 2006 7:05 am

P.S. When I mentioned that my tracks and/or clips were cutting out...it sounds like someone is taking an input cord, and yanking it in and out of a 1/4 jack. My master volume needle goes up and down in accordance to the in and out.

badnewsbearrec · Post by **badnewsbearrec** » Tue Jul 11, 2006 7:15 am

i think it has something to do with my audio driver, but dont know whtas up.

VeXKoN · Post by **VeXKoN** » Tue Jul 11, 2006 7:21 am

it's not going to have anything to do with ableton, try bumping up your latency (ms).

lunatic · Post by **lunatic** » Tue Jul 11, 2006 7:33 am

Sometimes I have a weird 10 Hz tremolo/noise effect, it goes away, if you set (in the preferences) the audio output to "no sound", and then back.

drez · Post by **drez** » Tue Jul 11, 2006 2:26 pm

What sound card are you using? What is it set at 44.1/16 or 96/24 or something different? ASIO or MME? What is your latency currently set to?

Mo' details needed.

Ableton Experts Help!!!