KVR Audio

tonymead · Post by **tonymead** » Sat Jul 15, 2006 7:43 pm

Hi there.

Is it possible to get an audio drum loop (with crap drum sounds) to trigger samples from a better drum sample library (dkfh for example). How would I go about doing this. I use Sonar v5 and Project5 v2.

Regards

Tony Mead

Spe3D · Post by **Spe3D** » Sat Jul 15, 2006 7:46 pm

Yes its possible - lots of ways to go about it - prob need yet another tool though.

Best regards,

Spe3d

:O)

PTV · Post by **PTV** » Sat Jul 15, 2006 7:48 pm

You can try to do it with KTDrumTrigger
(but it will take some work)
http://www.koen.smartelectronix.com/KTDrumTrigger/

tonymead · Post by **tonymead** » Sat Jul 15, 2006 8:57 pm

cool. Will try the KTDrum Trigger later this week.

thanks for the info

tm

scuzzphut · Post by **scuzzphut** » Sat Jul 15, 2006 9:48 pm

the other way would be to put the drum loop into a slicer

ext sampler
liveslice
microdicer
etc.

You will then get the groove intact and can replace drums at your leisure.

of course, slicers are just plain fun anyway

pHz · Post by **pHz** » Sat Jul 15, 2006 9:54 pm

aptrigga will do it too ...

slainte

rob

j_sun2k · Post by **j_sun2k** » Sun Jul 16, 2006 3:05 am

why dont you just replay the drumloop by yourself using the new drums? it shouldnt be hard.

PTV · Post by **PTV** » Tue Jul 18, 2006 6:44 am

You can also try 'replacer' (freeware): http://www.boxsounds.com/vst.html

Audio drum loop to trigger drum samples - how?