Making Reason RV7000 bigger sounding

[anapol25]

By testing RV7000 reverb from Reason i did found that this reverb is decent and can sound good in some situations but however it does lack of spatial information and some density(especialy plate algo when used on drums):? It can be loosed in mix with much elements. But this is case probably because of way how i mix so i cant blame RV7000 for all. But i dont have these problems in VST. So i spin in a loop and i try to figure this out. And i have some questions for you kvrers who use reason

How can you make RV7000 bigger? I dont have good results by chaining two devices but then again maybe i do miss something. Is there exist some trick or tip to make sound from this unit more denser? Maybe some eqing. Some phasing...Is there some good combis or anything which can enliven RV7000 a bit more?

Maybe there is some trick even from VST area or from general audio which can work?

Thank you!

[neilpullen]

Hi, you should try asking at the propellerhead forum www.propellerheads.se as there are lots of knowledgable Reason people there.

[shanecgriffo]

yeah , cause no one here uses reason.. hehe..

[Hovmod]

yeah , cause no one here uses reason.. hehe..

Sure we do. I don't have a good answer for anapol, though, because I don't have a strategy to make the RV7000 better. I think it's pretty easy to tweak, and when I don't find what I want there (which is rare), I'll go to some other reverb. I'm usually rewired...

[sloworm]

well, maybe you could try stacking a scream at tape setting after the rv7000....usually also a touch of delay will make it sound more lush...oh yes

[Amberience]

I think the RV7000 is one of the best reverbs out there, beats a lot of VST's for me. As to your enquiry, try delaying only one of the channels (left or right) by a few MS with a delay unit.