The A6 outs NRPN not standard CC so I created a generic controller in cubase assigned the NRPN knob of the A6 to a specific action of the NI PRO53... and well it works!
So I was very happy... but... I loaded another vst (Minimonsta) and when I turn the A6 knobs... well both (PRO53 and Minimonsta) knobs turns! For example I mapped CUTOFF and tweaking tha A6 cutoff I see both CUTOFF of Minimonsta and CUTOFF of PRO53 being tweaked.
Setting up the generic controller I choosed PRO53 (ch1) as destination, so why it seems to send a "broadcast midiCC" ? (both PRO53 and Minimonsta are setted to have the same midicc for cutoff). I loaded a third vst and well the knobs turns to it too...
Is it possible to avoid this ? Do I need to read the sx3 manual again ?
