KVR Audio

track7 · Post by **track7** » Wed Oct 11, 2006 5:41 am

Hello

I have Audiophile 24/96 + Cubase SX3 . When I in Cubase switch to M-Audio driver I can see only Audiophile Analog In L/R (in track input dialog) ... but S/PDIF L/R is missing (but in "device setup" are all VST Inputs available).
I tryed restart Cubase for example ....

Where is problem ? I need use S/PDIF IN for recording .
Thanks a lot

olepro · Post by **olepro** » Wed Oct 11, 2006 5:49 am

You have to set up your inputs inside vst connections.

Have a looke in the manual and read about vst connections.

track7 · Post by **track7** » Wed Oct 11, 2006 6:13 am

olepro wrote:You have to set up your inputs inside vst connections.

Have a looke in the manual and read about vst connections.

I see , but there I have only Audiophile Analog In L/R

.
S/PDIF is there missing too .

olepro · Post by **olepro** » Wed Oct 11, 2006 8:11 am

Hmmmm....

budweiser · Post by **budweiser** » Sat Oct 14, 2006 9:44 pm

you have to create a new port for your s/pdif. Did you ?

Lunch Money · Post by **Lunch Money** » Sat Oct 14, 2006 10:17 pm

It's more likely an Audiophile problem. Go to the Delta control panel... I don't have mine installed right now, so I can't remember which tab... but somewhere in there you need to specify which device is providing sync. If it doesn't sync, it won't reveal itself as an available input. What device are you sending to the S/PDIF?

track7 · Post by **track7** » Sun Oct 15, 2006 8:14 am

budweiser wrote:you have to create a new port for your s/pdif. Did you ?

It was my problem , I didnt understand , how do it ... thanks a lot to all !

SX3 + Audiophile 2496 missing s/pdif input !!